Çelik, Yahya HışmanÖzek, CebeliTürkan, Cihat2021-11-092021-11-092017-10Çelik, Y.H., Özek, C., Türkan, C. (2017). Investigation of turning in different cutting parameters of Al 6061 with finite elements method. 8th International Advanced Technologies Symposium, 19-22 October 2017, Elazığ, Turkeyhttp://iats17.firat.edu.tr/https://hdl.handle.net/20.500.12402/3903In this study, the effects of cutting parameters on cutting force, temperature and stress were investigated in the turning of 6061 aluminum alloy by using DEFORM-3D package program based on finite element method. Constant depth of cut (1 mm), three different cutting speeds (40, 60 and 80 m/min), and three different feed rates (0.05, 0.1 and 0.15 mm/rev) were used in research simulations. From the made analyses, the lowest cutting force was obtained as 150 N at 80 m/min cutting speed and 0.05 mm/rev feed rate, the highest cutting force was obtained as 368 N at 40 m/min cutting speed and 0.15 mm/rev feed rate. While the lowest temperature was obtained as 230 °C at 40 m/min cutting speed and 0.05 mm/rev feed rate, the highest temperature was obtained as 354 °C at 80 m/min cutting speed and 0.05 mm/rev feed rate. In addition, the lowest stress was 997 MPa at 80 m/min cutting speed and 0.05 mm/rev feed rate, the maximum stress was 1090 MPa at 40 m/min cutting speed and 0.15 mm/rev feed rate. It has been observed that the cutting force and the stress value show a similar tendency depending on the cutting parameterstrinfo:eu-repo/semantics/openAccessAttribution-NonCommercial-ShareAlike 3.0 United StatesAl 6061Cutting ForceFinite ElementsStressTurningConference Object