3 sonuçlar
Arama Sonuçları
Listeleniyor 1 - 3 / 3
Öğe Investigation of experimental study of end milling of CFRP composite(De Gruyter, 2013-12-12) Çelik, Yahya Hışman; Kılıçkap, Erol; Yardımeden, AhmetCarbon fiber-reinforced plastic (CFRP) composites are materials that are difficult to machine due to the anisotropic and heterogeneous properties of the material and poor surface quality, which can be seen during the machining process. The machining of these materials causes delamination and surface roughness owing to excessive cutting forces. This causes the material not to be used. The reduction of damage and surface roughness is an important aspect for product quality. Therefore, the experimental study carried out on milling of CFRP composite material is of great importance. End milling tests were performed at CNC milling vertical machining center. In the experiments, parameters considered for the end milling of CFRP were cutting speed, feed rate, and flute number of end mill. The results showed that damage, surface roughness, and cutting forces were affected by cutting parameters and flute number of end mill. The best machining conditions were achieved at low feed rate and four-flute end mill.Öğe An experimental study on milling of natural fiber (jute)- reinforced polymer composites(SAGE, 2019-01-31) Çelik, Yahya Hışman; Kılıçkap, Erol; Kılıçkap, Ali İmranThe interest in materials having natural, environmentally friendly, renewable and low density/cost is increasing day by day due to sanctions imposed to reduce the emission rates, especially the Kyoto Protocol. In recent years, the use of environmentally friendly composites by using natural fibers such as flax, jute and sisal has increased in engineering applications. Milling operation has frequently been an important method of machining which can achieve the desired dimensions and tolerances for the plate-shaped parts. In this study, the effects of cutting parameters such as cutting speed and feed rate on cutting force, delamination factor and surface roughness in end milling of jute fiber-reinforced polymer composite plates with different orientation angle (0°/90°, 30°/−60° and ±45°) were examined by using the cemented carbide (WC) end mills (two, three and four number of flutes). Cutting force, deformation factor and surface roughness were found to be influenced by the feed rate and cutting speeds. In addition, increasing the number of the flutes of the cutting tools reduced the cutting force, delamination factor and surface roughness.Öğe An investigation of the effect of parameters and chip slenderness ratio on drilling process quality of AISI 1050 steel(Hindawi, 2018-05-08) Demir, Zülküf; Yakut, RıfatThe chip slenderness ratio is a vital parameter in theoretical and applicable machining operations. In predrilled drilling operations of AISI 1050 steel alloy, HSS drills were employed, and the effect of the selected parameters on the chip slenderness ratio and also the effect of the chip slenderness ratio on the thrust force, surface roughness, drilled hole delamination, tool wear, and chip morphology were investigated. The major parameters, influential on the chip slenderness ratio, were feed rate and point angle, while spindle speed was too small to be negligible. With increasing the chip slenderness ratio, the thrust force and the tool wear decreased, which resulted in appropriate chip morphology, but there were increases in surface roughness. However, the chip slenderness ratio had no effect on the drilled hole delamination.
