Strength and failure analysis of inverse Z joints bonded with Vinylester Atlac 580 and Flexo Tix adhesives
Yükleniyor...
Tarih
2012-11
Yazarlar
Dergi Başlığı
Dergi ISSN
Cilt Başlığı
Yayıncı
Springer
Erişim Hakkı
info:eu-repo/semantics/closedAccess
Attribution-NonCommercial-ShareAlike 3.0 United States
Attribution-NonCommercial-ShareAlike 3.0 United States
Özet
In this study, the tensile strength and failure loads of the inverse Z joints were analyzed both experimentally and numerically by using
two adhesives with different properties under a tensile load. Vinylester Atlac 580 and Flexo Tix were used as adhesives and the joints
were prepared with two different composite materials. Initially, the mechanical properties of the adhesives were specified using bulk
specimens. Then, the stress analyses were performed using three-dimensional finite element method (3-D FEM) via Ansys (V.10.0.1).
The experimental results were compared with the numerical results and they were found quite reasonable. According to the test results, it
can be seen that when the adherend thickness is increased, the stress increases as well. The most appropriate value of the adherend thickness
is identified as t = 5 mm. Furthermore, it was observed that the lowest failure load was obtained at t = 3 mm the thickness for each
specimen.
Açıklama
Anahtar Kelimeler
Adhesive, Composite Material, Stress Analysis, Ansys, Finite Element Method (FEM)
Kaynak
WoS Q Değeri
Q3
Scopus Q Değeri
Q2
Cilt
26
Sayı
11
Künye
Adin, H., Turgut, A. (2012). Strength and failure analysis of inverse Z joints bonded with Vinylester Atlac 580 and Flexo Tix adhesives. Journal of Mechanical Science and Technology, 26(11), pp. 3453-3461. https://doi.org/10.1007/s12206-012-0873-x
