4 sonuçlar
Arama Sonuçları
Listeleniyor 1 - 4 / 4
Öğe Assessment of heavy metal pollution of urban soils of Batman by multiple pollution indices(Taylor & Francis, 2021-03-28) Baran, Hacı Alim; Gümüş Kıral, NurcanHeavy metal accumulation is observed in urban soils, sometimes due to anthropological effects and sometimes due to natural geological units. In order to determine the heavy metal content of the Upper MioceneLower Pliocene Selmo Formation, which is observed in the whole study area and consists of conglomerate, sandstone and silt stone, soil and river sediment samples were taken. Within the scope of pollution assessment, geo-accumulation index (Igeo), enrichment factor (EF) and pollution index (PI) calculations of Batman urban soil samples were made and different degrees of pollution values were determined. High pollution values were obtained for As, Mo and Sb elements in all pollution indices calculated. The pollution levels of the three elements were determined as strongly to extremely contaminated according to Igeo values, the others except As (very severe enrichment) according to EF values were determined as severe enrichment, and according to PI, all three were determined as strong polluted. Pollution and element distribution maps were created with a geographical information system software. According to the results of correlation analysis and cluster analysis, the elements found to be contaminated are divided into two groups, whose locations and sources of contamination are different. The first group (Sn, Zn and Pb) is observed in the approximate centre of the study area and developed due to traffic emissions. The elements belonging to the second group (especially As, Mo and Sb) show high pollution values in the south-southeast of the study area. These pollutions are thought to be caused by the inadequate storage of mineral oils and batteries that are changed in the industrial site and from leaks in the oil production, storage, refining and transmission phase in TPAO, TÜPRAŞ and BOTAŞ. The analysed samples were compared with the Soil Pollution Control Regulation and WHO standards, and Co, Ni and As element values were found to exceed the permissible values for healthÖğe Electrical properties of safranine T p Si organic inorganic semiconductor devices(Cambridge University, 2010-04-25) Güllü, Ömer; Asubay, Sezai; Biber, Mehmet; Kılıçoğlu, Tahsin; Turut, AbdulmecitWe investigated the current-voltage (I-V) and capacitance-voltage (C-V) characteristics of identically prepared safranine T/p-Si organic/inorganic Schottky devices (total 26 diodes) formed by evaporation of organic compound solution on p-Si semiconductor substrate. It was seen that the safranine T organic thin film on the p-Si substrate showed a good rectifying behavior. The barrier heights and ideality factors of all devices were extracted from the electrical characteristics. The mean barrier height and mean ideality factor from I-V measurements were calculated as 0.59±0.02 eV and 1.80±0.20, respectively. Also, the mean barrier height and mean acceptor doping concentration from C-V measurements were calculated as 0.67±0.10 eV and (6.96±0.37)×1014 cm-3, respectively. The discrepancy in the barrier height values obtained from I-V and C-V characteristics has been attributed to different nature of the measurements. The discrepancy between these values can also be due to the existence of the interfacial native oxide and the organic safranine T thin layer between the semiconductor substrate and top contact metal.Öğe Room temperature I–V and C–V characteristics of Au/mTPP/p-Si organic MIS devices(The European Physical Journal Applied Physics, 2018-05-02) Güllü, Ömer; Pakma, Osman; Özden, ŞadanThe room temperature electrical characteristics of the organic Au/mTPP/p-Si device fabricated by spin coating method were investigated with I–V and C–V measurements. It has been determined that the device has a high rectification coefficient and current transport is dominated by the thermionic emission. The serial resistance value is calculated at 92 ohms with two different approaches. Serial resistance effects were also found to be effective in C–V and G–V measurements. The different barrier heights from the I–V and C–V measurements indicate possible interface and trap states or barrier inhomogeneities.Öğe Experimental investigation of thermal performance in a concentric tube heat exchanger with wavy inner pipe(SpringerLink, 2012-06) Argunhan, Zeki; Çakmak, Gülşah; Yücel, Halit Lutfi; Yıldız, CengizIn this article, the heat transfer, friction factor, and thermal performance factor characteristics of a concentric-tube heat exchanger are examined experimentally. A wavy inner pipe is mounted in the tube with the purpose of generating swirl flow that would help to increase the heat transfer rate of the tube. The examination is performed for a Reynolds number ranging from 2700 to 8800. An empirical correlation is also formulated to match with experimental data of the Nusselt number using the Wilson plot method. In addition, to obtain the real benefits in using the swirl generator at a constant pumping power, the thermal enhancement factor is also determined. Over the range considered, the increases in the Nusselt number, friction factor, and thermal performance factor are found to be, respectively, about 113 %, 81 %, and 196 % higher than those obtained from a smooth-surface inner pipe.
