38 sonuçlar
Arama Sonuçları
Listeleniyor 1 - 10 / 38
Öğe Design of PV energy system in Batman Turkey(AIP Conf.Proc., 2017) Pakma, Nilay; Pakma, Osman; Güllü, ÖmerÖğe Fabrication and electrical characterization of ZnO SiO2 p Si structure with outsized diode factor(European Union, 2010) Kavasoğlu, Neşe; Kavasoğlu, Abdülkadir Sertap; Pakma, Osman; Kabakçı, Murat; Birgi, Özcan; Oktik, ŞenerÖğe Temperature dependent electrical transport in Al/Poly(4-vinyl phenol)/ p -GaAs metal-oxide-semiconductor by sol-gel spin coating method(Hindawi, 2016-03-10) Özden, Şadan; Tozlu, Cem; Pakma, OsmanDeposition of poly(4-vinyl phenol) insulator layer is carried out by applying the spin coating technique onto p-type GaAs substrate so as to create Al/poly(4-vinyl phenol)/p-GaAs metal-oxide-semiconductor (MOS) structure. Temperature was set to 80-320 K while the current-voltage (I-V) characteristics of the structure were examined in the study. Ideality factor (n) and barrier height (φ b) values found in the experiment ranged from 3.13 and 0.616 eV (320 K) to 11.56 and 0.147 eV (80 K). Comparing the thermionic field emission theory and thermionic emission theory, the temperature dependent ideality factor behavior displayed that thermionic field emission theory is more valid than the latter. The calculated tunneling energy was 96 meV.Öğe Frequency dependent interface state properties of a schottky device based on coronene deposited on n-type silicon by spin coating technique(Ulusal Fotovoltaik Teknoloji Platformu, 2016) Yüksel, Ömer Faruk; Pakma, Osman; Tuğluoğlu, NihatÖğe Batman ilindeki ince film a-Si teknolojili fotovoltaik sistemin performans değerlendirmesi(Balıkesir Üniversitesi, 2018-07-17) Pakma, OsmanBu çalışmada Batman ilinde ince film a-Si teknolojisine sahip 2.16 kWp güce sahip şebeke bağlantılı sistemin bir yıllık elektrik enerjisi üretim verileri alınmış ve modüllerin performansı dış parametrelerde göz önüne alınarak değerlendirilmiştir. Sistem ölçümleri Ocak ayından Aralık ayına kadar tüm 2016 yılını kapsamaktadır. İnce film a-Si PV sistemden 2016 yılı süresince şebekeye 2.631 MWh enerji sağlanmıştır. Sistemin nihai verimi (Yf) 1.13 den 4.89 kWh/KWp/gün’e, performans oranı da (PO) %53 ile %78 arasında değişmektedir. Ortam ve buna bağlı olarak modül sıcaklıklarının sistem performansına etkisinin %6 - %9 arasında olduğu hesaplanmıştır. Ayrıca diğer sistem bölümlerinin de sistem performansı üzerinde değişen oranlarda etkili olduğu belirlenmiştir.Öğe Ag-doped HfO2 thin films via sol–gel dip coating method(Springer Nature, 2019-10-01) Pakma, Osman; Kaval, Şehmus; Kari̇per, İshak AfşinIn this study, undoped and Ag-doped HfO2 thin films were deposited on glass substrates by means of sol–gel dip coating method. These films were then thermally annealed at 500 °C for 1 h. The structural and optical properties of undoped and Ag-doped HfO2 thin films were characterized by X-ray diffraction, UV–Vis spectrometry and scanning electron microscope. The results of this analysis were compared and interpreted with the results obtained in literature by various methods of coating with HfO2. The X-ray diffraction peaks of the films paired with monoclinic HfO2 crystalline peaks. The refractive indices of the films decreased with doping Ag, at 500 nm wavelengths. The optical band gap values of Ag-doped HfO2 thin films increased with doping Ag. The porous structures were observed on the surface films, especially with 5% Ag doping.Öğe Some electrical parameters of the Sn/p-Si diode under γ-irradiation(Çukurova Üniversitesi, 2017) Pakma, Osman; Güllü, ÖmerThe radiation response of metal-semiconductor (MS) contacts has been found to alter significantly when the structures are exposed to pre-irradiation processes at determined doses. Radiation doses greater than a kilogray exposure may cause strong changes on the electrical characteristics of MS structures. It has been also shown that the particle or gamma irradiations induce defects in the band gap which affects the free carrier concentration and leads to an increase and decrease of barrier height in p-type and n-type semiconductors, respectively. The knowledge of the influence of radiation damage on the Schottky barrier diodes (SBDs) performance is a fundamental field of research, having technological relevance for many applications in the semiconductor electronic devices. Hence, it is very much essential to evaluate the effect of irradiation and identify the degradation mechanism to understand the failure mechanisms. In this work, we have investigated the electrical parameters of the Sn/p-Si Schottky barrier diodes by using I-V and C-V characteristics under γ-irradiation at room temperature. The basic diode parameters such as ideality factor, barrier height, series resistance and reverse saturation current were extracted from electrical measurements as a function of the irradiation dose. The results indicated that γ-irradiation induced an increase in the effective Schottky barrier height extracted from both I-V and C-V measurements. Also, it was seen that ideality factor increased with the increasing γ-irradiation doses. We have also observed that the reverse bias current of the Sn/Si contact exceedingly decreased with increasing irradiation dose with low energy (60 keV). The basic results as related to the gamma irradiation have been indicated that this device may have applications as radiation sensors in order to detect the low energy gamma radiation.Öğe Characterization of Au N Inp photovoltaic structure with organic thin film(Uppsala University, 2012) Güllü, Ömer; Özerden, Enise; Rüzgar, Şerif; Asubay, Sezai; Pakma, Osman; Kılıçoğlu, Tahsin; Türüt, AbdulmecitÖğe The effects of high-energy electron irradiation on the electrical characteristics of a lead/rhodamine-101/p-Si diode(Çukurova Üniversitesi, 2017) Güllü, Ömer; Pakma, OsmanHigh-energy radiation penetrates the metal-semiconductor (MS) interface and causes damage deep below the interface. Low-energy radiation causes severe lattice damage in the form of vacancies, interstitials and defect complexes at the near interface of the device. The one kind of the radiation is electron beam which is accelerated. Mills was the first to recognize that electrons with energy of 1 MeV would possess enough energy to displace an atom from its lattice position. This observation has led to the increased use of electron accelerators in radiation damage studies. This use has been motivated by two important facts. First, electron bombardment experiments permit the determination of the energy required to remove an atom from its initial position. This is done by increasing the energy of the electrons until an observable change in a radiation-sensitive property is seen. The second important basis for the use electrons lie in the fact that as long as the energy of the electrons is close to the displacement threshold, it is presumed, that only single Frenkel pairs are formed. Thus, many radiation-induced phenomena can be analyzed in terms of a single vacancy and/or interstitial atom, and one avoids the complication attendant upon the generation of complex damage regions presumed to occur in heavy-charged particle irradiation. In the present paper, a lead/rhodamine-101(Rh101)/p-Si metal/organic interlayer/ semi-conductor diode was fabricated and the effect of 6 MeV-electron irradiation on the electrical characteristics of the diode structure was investigated. It was seen that after electron irradiation the barrier height values, the series resistance values and ideality factors increased. Furthermore, it was seen that the capacitance values increased after electron irradiation. This was attributed to the change in dielectric constant at the interface and/or to decrease in the net ionized dopant concentration and the interface states. The degradation of the diode properties may be due to the introduction of electron irradiationinduced interfacial defects via displacement damage.Öğe Wet chemical methods for producing mixing crystalline phase ZrO 2 thin film(Elsevier, 2016-07) Pakma, Osman; Özdemir, Cengiz; Kariper, İshak Afşin; Özaydın, Cihat; Güllü, ÖmerThe aim of the study is to develop a more economical and easier method for obtaining ZrO 2 thin films at lower temperature, unlike the ones mentioned in the literature. For this purpose, wet chemical synthesis methods have been tested and XRD, UV-VIS and SEM analysis of ZrO 2 thin films have been performed. At the end of the analysis, we identified the best method and it has been found that the features of the films produced with this method were better than the films produced by using different reagents, as well as the films reported in the literature. Especially it has been observed that the transmittance of the film produced with this method were higher and better than the films in the literature and the others. In addition, refractive index of the film produced with this method was observed to be lower. Moreover, by using the same method Al/ZrO 2 /p-Si structure has been obtained and it has been compared with Al/p-Si reference structure in terms of electrical parameters.
