5 sonuçlar
Arama Sonuçları
Listeleniyor 1 - 5 / 5
Öğe Analysis of combustion, performance and emission characteristics of a diesel engine using low sulfur tire fuel(Elsevier, 2015-03-01) Aydın, Hüseyin; İlkılıç, CumaliAn alternative fuel for diesel engines was produced from waste vehicle tires by the method of pyrolysis. In order to reduce sulfur content of produced the liquid fuels, during the reaction Ca(OH) 2 was used. Then, H 2 SO 4 were used after the reaction and the sulfur content of the product was reduced by 83.75%. The properties of diesel fuel, low sulfur tire fuel and fuel mixtures of low sulfur tire fuel and diesel fuel were found. Then the prepared fuel blends and diesel fuel were tested in a diesel engine. Performance, combustion and emission parameters of the engine when using each fuel were obtained and comparisons were made with D2 fuel. Power, torque and mean effective pressure, mass fuel consumption, effective efficiency and bscf values presented. Results justify that the performance of the engine slightly lowers by using blends of LSTF. Cylinder pressure and heat release rate values of the test fuels usage were quite similar with those of D2. CO, HC, and smoke emissions were slightly higher while NOx emissions were lower for LSTF blends. All of these results indicate that desulfurized tire fuels with low percentages can be used as alternative fuel in diesel engine.Öğe Experimental investigation of the effects of diesel-like fuel obtained from waste lubrication oil on engine performance and exhaust emission(Journals & Books, 2010-10) Argunhan, Zeki; Yumrutaş, Recep; Arpa, OrhanIn this study, effects of diesel-like fuel (DLF) on engine performance and exhaust emission are investigated experimentally. The DLF is produced from waste engine lubrication oil purified from dust, heavy carbon soot, metal particles, gum-type materials and other impurities. A fuel production system mainly consisting of a waste oil storage tank, filters, a reactor, oil pump, a product storage tank, thermostats and control panel is designed and manufactured. The DLF is produced by using the system and applying pyrolitic distillation method. Characteristics, performance and exhaust emissions tests of the produced DLF are carried out at the end of the production. The characteristic tests such as density, viscosity, flash point, heating value, sulfur content and distillation of the DLF sample are performed utilizing test equipments presented in motor laboratory of Mechanical Engineering Department, University of Gaziantep, Turkey. Performance and exhaust emission tests for the DLF are performed using diesel test engine. It is observed from the test results that about 60 cc out of each 100 cc of the waste oil are converted into the DLF. Characteristics and distillation temperatures of the DLF are close to those values of a typical diesel fuel sample. It is observed that the produced DLF can be used in diesel engines without any problem in terms of engine performance. The DLF increases torque, brake mean effective pressure, brake thermal efficiency and decreases brake specific fuel consumption of the engine for full power of operation.Öğe Using gasoline-like fuel obtained from waste automobile tires in a spark-ignited engine(Taylor & Francis, 2014-05-01) Altun, Şehmus; Varol, Yasin; Öztop, Hakan Fehmi; Fırat, MüjdatAn experimental study on performance and exhaust emission of a spark-ignited engine fueled by gasoline-like fuel obtained from waste automobile tires using the prolysis process was performed in this study. Gasoline-like fuel has a higher octane number than unleaded gasoline; however, it has higher in viscosity in comparison to unleaded gasoline, which limited the use of gasoline-like fuel in neat form. Therefore, gasoline-like fuel was blended with unleaded gasoline from 0% to 100% with an increment of 10%, volumetrically. Obtained blends were then used in a spark-ignited engine. It was observed that the test engine was normally run up to blended fuel containing gasoline-like fuel of 60%. It is concluded that gasoline-like fuel can be partially substituted for the gasoline fuel up to 60% in blended form in terms of performance parameters and emissions without any engine modification.Öğe Optimization of fuel production from waste vehicle tires by pyrolysis and resembling to diesel fuel by various desulfurization methods(Elsevier, 2012-12) Aydın, HüseyinIn this study, an alternative fuel for diesel engines was produced from waste automobile tires by the method of pyrolysis. In order to reduce the high sulfur content of the fuel, CaO, Ca(OH) 2, and NaOH catalysts were used. In addition, effects of variables such as temperature, the catalyst ratio and the N2 flow rate on yield were investigated. The highest product yield was obtained with temperature of 500 °C and 200 cm 3/min N 2 flow rate. When compared with the products obtained from initial pyrolysis, the sulfur content of the product was found to be 34.25% lower with the utilization of 5% Ca(OH) 2 in the reaction. In order to make the sulfur content of the product closer diesel fuel, the acetic acidH 2O 2, formic acidH 2O 2 and H 2SO 2 were used in different proportions. Although, the other acids were also very effective, the use of 10% H 2SO 4 reduced sulfur content of the product by 75.27%. Thus, with 5% Ca(OH) 2 and then with addition of 10% H 2SO 4, the sulfur content of the product was reduced by 83.75%. The properties of diesel fuel (DF), liquid fuel derived from waste vehicle tires (TF), low sulfur tire fuel (LSTF) and fuel mixtures of LSTFDF were analyzed. It was found that, the density and sulfur content of LSTF fuel were slightly higher than that of diesel fuel, but other features and distillation curves were very close to diesel fuel.Öğe Fuel production from waste vehicle tires by catalytic pyrolysis and its application in a diesel engine(Journals & Books, 2011-05) Aydın, Hüseyin; İlkılıç, CumaliAn alternative fuel production was performed by pyrolysis of waste vehicle tires under nitrogen (N2) environment and with calcium hydroxide (Ca(OH)2) as catalyst. The sulfur content of liquids obtained were reduced by using Ca(OH)2. The liquid fuel of waste vehicle tires(TF) was then used in a diesel engine to blend with petroleum diesel fuel by 5%(TF5), 10%(TF10), 15%(TF15), 25%(TF25), 35%(TF35), 50%(TF50), and 75%(TF75) wt. and pure (TF100). Performance characteristics such as engine power, engine torque, brake specific fuel consumption (bsfc) and exhaust temperature and emission parameters such as oxides of nitrogen (NOx), carbon monoxides (CO), total unburned hydrocarbon (HC), sulfur dioxides (SO2) and smoke opacity of the engine operation with TF and blend fuels of TF–diesel were experimentally investigated and compared with those of petroleum diesel fuel. It was concluded that the blends of pyrolysis oil of waste tires TF5, TF10, TF25 and TF35 can efficiently be used in diesel engines without any engine modifications. However, the blends of TF50, TF75 and TF100 resulted considerably to high CO, HC, SO2 and smoke emissions.
