Arama Sonuçları
Listeleniyor 1 - 10 / 48
Öğe N-type InP Schottky diodes with organic thin layer: Electrical and interfacial properties(Journal of Vacuum Science & Technology B, 2010-03) Güllü, Ömer; Turut, AbdulmecitThe rectifying junction characteristics of methyl red (MR) organic film on n-type InP substrate have been studied. It has been observed that MR-based structure shows an excellent rectifying behavior and that the MR film increases the effective barrier height by influencing the space charge region of the n-type InP. The barrier height and ideality factor values for this structure have been obtained as 0.75 eV and 1.93 from the forward bias current-voltage characteristics, respectively. By using capacitance-voltage characteristics at 1 MHz, the barrier height and the carrier concentration values have been calculated as 0.93 eV and 5.13×1015 cm−3, respectively. The energy distributions of the interface states and their relaxation times have been determined from the forward bias capacitance-frequency and conductance-frequency characteristics. Moreover, it was seen that both the interface-state density and the relaxation time of the interface states decreased with bias voltage from experimental results.Öğe Investigation of plasma arc cutting parameters with type-2 fuzzy set and system(De Gruyter, 2013-10) Çelik, Yahya Hışman; Özek, Cebeli; Bulut Özek, MüzeyyenThe objective of the present study was it to design a type-2 fuzzy set and system in order to predict surface roughness and hardness depending on the parameters (material thickness, cutting speed, arc voltage and current) of the plasma arc cutting process of S235JR sheet materials. Therefore, some experimental studies were conducted. The experimentally determined data were used to describe the type-2 fuzzy set and system. Type-2 fuzzy set and system was found to be usefull to predict surface roughnes and hardness. According to the obtained values, the best surface roughness and the values closest to the hardness of the raw material were obtained at 1500 mm/min cutting speed, 8 mm material thickness, 115 V arc voltage and 80 A current.Öğe An exergy analysis of a concentric tube heat exchanger using hBN-water nanofluids(Inder Science Publishers, 2021) Budak Ziyadanoğulları, Neşe; Perçin, SüleymanThis study investigated the effects of using nanofluids prepared with hexagonal boron nitride (hBN) nanoparticles on the thermal performance and pressure drop of a concentric tube heat exchanger. Experiments were carried out with water-hBN nanofluids for stable, dispersed, 0.01%, 0.1% and 1% volume concentrations, at different flow rates and Reynolds numbers under parallel and counter-flow conditions. When the experimental results were examined, the exergy loss was higher in the parallel-flow heat exchanger compared to the counter-flow heat exchanger. The highest exergy loss value was obtained for distilled water at the highest Reynolds number (Re = 8,700) for parallel flow operation at 170 W. The exergy loss of water at the highest Reynolds number (Re = 8,700) for parallel flow operation increased by 15.7%, 24.8% and 49.8% for hBN-water concentrations of 0.01%, 0.1% and 1%, respectively. Exergy loss of water at the highest Reynold number (Re = 8,700) for counter flow operation increased by 11.3%, 17.3% and 29.2% for hBN-water concentrations of 0.01%, 0.1% and 1%, respectively. When evaluating the exergy analysis of the system, exergy losses due to pressure drops were negligible for both flows (parallel and counter).Öğe The effect of intrapreneurship and organizational factors on the innovation performance in hospital(Expert Projects, 2018-09) Ekingen, Erhan; Ekemen, Mehmet Ali; Yıldız, Ahmet; Korkmazer, FuatIn the context of environmental uncertainty and competition, organizations are trying to find new ways to improve their performance. The development of novelties based on innovation, especially in the service sector, is the departure point for many organizations. Intrapreneurship and organizational structure are important factors for organizations to improve the innovation performance. In this study, it is aimed to investigate whether intrapreneurship and organizational factors influence the innovation performance. The data were collected from a hospital by means of intrapreneurship scale, organizational factors scale and innovation performance scale. According to the results of Structural Equation Model analysis, intrapreneurship has positive influences on innovation performance. Organizational factors directly and indirectly affect innovation performance. Moreover, intrapreneurship has mediation effect between organizational factors and innovation performance. Lastly, Intrapreneurship enhances the effect of organizational factors on innovation performance.Öğe The changes in the serum, liver, kidney protein and genomic DNA profiles in rats treated with 7,12-Dimethylbenz(A) anthracene and Plantago major L.(RJPBCS, 2014-01) Berber, İsmet; Ekin, Suat; Levent, Abdulkadir; Oto, Gökhan;In the study, the changes in the serum, liver, kidney protein and genomic DNA profiles in Wistar albino rats administrated to 7,12-dimethylbenz(a)anthracene (DMBA) and Plantagomajor L. were investigated. SDS-PAGE profiling of the serum proteins showed that the levels of two proteins molecular weighing 140.8 kDa and 46.8 kDa were significantly lower on the 0th day of treatment than on the 60th day of application in the groups. Furthermore, two proteins (34.5 and 22.3 kDa) were solely present in DMBA-treated liver cell lysates. On the contrary, the kidney protein profiles did not show significant banding variations in groups. Genomic DNA analysis also confirmed that DNA extracted from liver and kidney cells did not fragment in any of the groups after the 60th study day. The proteins 34.5 and 22.3 kDa in liver cell lysates at the 60th day in DMBA-treated group could be extra-prognostic indicators for severe DMBA toxicity.Öğe Dimension and insulation thickness optimization of circular flat plate solar collectors(Energy Education Science and Technology, 2011) Argunhan, ZekiIn this study, expressions for optimum radius of a circular flat plate solar collector and the optimum insulation thickness distribution are derived by using the concept of solar gain, which maximizes the life-cycle savings. For the specified condition the optimum radius has been found as 2.14 m and the optimum insulation thickness distribution on back of collectors has been formulized. The insulation material thickness distribution has been determined by performing a detailed dimensional analysis; therefore heat loss is minimized, and results are presented in graphics.Öğe Plantago major protective effects on antioxidant status after administration of 7,12-dimethylbenz(a)anthracene in rats(Asian Pacific Organization for Cancer Prevention, 2011) Oto, Gökhan; Ekin, Suat; Özdemir, Hülya; Demir, Halit; Yaşar, Semih; Levent, Abdulkadir; Berber, İsmet; Kaki, BarışAim: The present study was designed to evaluate effects of Plantago major extract on oxidative status in Wistar albino rats administrated 7,12-dimethylbenz(a)anthracene (DMBA). Methods: Rats were divided into three equal groups of 6 animals each: Group 1 controls, group 2 treated with DMBA (100 mg/kg, single dose) and group 3 receiving the DMBA and the aqueous extract at 100 mg/kg/d for 60 days. Results: Significant decrease in catalase (P<0.05), carbonic anhydrase (p≤0.01), reduced glutathione (GSH) (P<0.01) and total protein (P<0.01) values was observed in the DMBA group compared with the healthy controls and DMBA + Plantago major groups. Conclusion: The results suggest preventive effects of Plantago major on DMBA induced oxidative damage in Wistar albino rats that might be due to decreased free radical generation.Öğe The effects of injection pressure on the engine performance characteristics of a CI engine fueled with canola oil-diesel blends(Energy Education Science and Technology Part A: Energy Science and Research, 2012-01) Aydın, HüseyinThe usage of vegetable oils in diesel engines has some negative effects especially on engine performance. Therefore vegetable oils can not be used as pure form or with high percentages in diesel fuel in unmodified diesel engines. Some of the engine operation conditions should be improved by modifying engine operation systems for this purpose. The effects of injection pressure on engine performance of a diesel engine, by using two different blends of vegetable oil (canola oil) in diesel fuel (DF) having a concentration of 20% (O20) and 50% (O50) vegetable oil, were studied in the present work. The injection pressure was changed from 200 MPa to 220 MPa. Tests were made at fully loaded engine and different speeds of engine operation. In the experiments, the engine power, torque, brake specific fuel consumption (Bsfc), mass fuel consumption rate, brake thermal efficiency and exhaust gas temperature of the test engine have been investigated. Results revealed that the increased injection pressure can significantly promote performance parameters of diesel engine with using vegetable oil without any modification either in oil or in engine itself. The improved results of experiments have been given as graphics in this paper.Öğe Influence of yogurt adding on physicochemical and sensorial properties of some lettuce types(WFL Publisher, 2013) Tarakçı, Zekai; Uǧur, Atnan; Temiz, Hasan; Dağ, BeşirThe aim of this study was to investigate the effects of adding yogurt and roasting treatment on some physicochemical, L*, a* and b* colour values and organoleptic acceptability properties of lettuce types. The 10 different lettuce varieties included kasam, mangano, robinson, olenka, arapsaçi{dotless}, red leaf, lolorosso, red salat, palamet and salanova were used. After cleaning and cutting into 0.5 mm, the lettuces were roasted with equal amount added yogurt for about 5 min and then applied to the mixing process. There were significant differences in dry matter and pH values between the lettuces added yogurt and raw lettuces. While dry matter of lettuces was increased significantly with yogurt, the pH levels were decreased. The whiteness values (L*) for lettuces have caused significant differences by adding yogurt and roasting applications. L* values of control sample without lettuces were significantly higher than the samples prepared by adding yogurt to lettuces. Lettuce types had a significant effect on the L* colour of samples. The lettuces were a significant a* color values between before and after roasting. After adding yogurt to lettuces; b* values of kasam, robinson and olenka colour values were significantly higher than the other samples prepared by adding yogurt to lettuce types. The lowest overall acceptability scores were detected for olenka, robinson and lolorosso lettuce types while the highest overall acceptability scores were detected for arapsaci, red salat and salanova lettuce types, which were common use in Turkish meals.Öğe Morphological, structural and optical characteristics of graphene oxide layers and metal/interlayer/semiconductor photovoltaic diode application(National Institute of Research and Development for Optoelectronics, 2018) Güllü, Ömer; Çankaya, MuratThis work describes the optical, morphological and structural characterizations of graphene oxide (GO) layers grown by drop casting and annealing process. UV-vis optical measurement shows that the values of direct and indirect optical gap energy of the GO film are 3.89 eV and 3.21 eV, respectively. The graphene oxide (GO) layer has been placed in the metal/ interlayer /semiconductor (MIS) diodes (total 17 devices) on p-Si wafers. The graphene oxide diodes give a better barrier height enhancement as compared with the conventional diodes. The value of homogeneous barrier height for Al/GO/p-Si MIS junctions was extracted as 0.74 eV. The diodes were also investigated under 300 watt light illumination for photovoltaic applications. Additionally, interfacial properties of the MIS diode with GO interlayer were determined. It has been seen that the capacitance of the device changes as a function of gate voltage and signal frequency from the capacitance-frequency measurements. It has also been reported that the interfacial trap charges reduce the capacitance with increasing frequency values.
