11 sonuçlar
Arama Sonuçları
Listeleniyor 1 - 10 / 11
Öğe Electrical characteristics of the Al/Congo Red (CR)/p-Si semiconductor diodes(Dumlupınar Üniversitesi, 2015-05) Güllü, Ömer; Pakma, Osman; Turut, Abdulmecit; Arsel, İsmailIn this work, we have studied the electrical characteristics of the Al/CR/p-Si MIS Schottky structures formed by coating of the organic material directly on p-Si substrate. It has been seen that the CR thin film on the p-Si substrate has indicated a good rectifying behavior. The barrier height and the ideality factor of the device have been calculated from the I-V characteristic. We have also studied the suitability and possibility of the MIS diodes for use in barrier modification of Si MS diodes. In addition, we have compared the parameters of the Al/CR/p-Si MIS Schottky diodes with those of conventional Al/p-Si MS diodes. We have observed that the b value of 0.77 eV obtained for the Al/CR/p-Si device was significantly larger than BH value of the conventional Al/p-Si MS contact. Thus, the modification of the interfacial potential barrier for metal/Si diodes has been achieved by using the CR organic interlayer. This was attributed to the fact that the CR interlayer increased the effective b by influencing the space charge region of Si. The interface-state density of the MIS diode was found to vary from 1.24×1013 eV-1 cm-2 to 2.44×1012 eV-1 cm-2.Öğe Morphological, structural and optical characteristics of graphene oxide layers and metal/interlayer/semiconductor photovoltaic diode application(National Institute of Research and Development for Optoelectronics, 2018) Güllü, Ömer; Çankaya, MuratThis work describes the optical, morphological and structural characterizations of graphene oxide (GO) layers grown by drop casting and annealing process. UV-vis optical measurement shows that the values of direct and indirect optical gap energy of the GO film are 3.89 eV and 3.21 eV, respectively. The graphene oxide (GO) layer has been placed in the metal/ interlayer /semiconductor (MIS) diodes (total 17 devices) on p-Si wafers. The graphene oxide diodes give a better barrier height enhancement as compared with the conventional diodes. The value of homogeneous barrier height for Al/GO/p-Si MIS junctions was extracted as 0.74 eV. The diodes were also investigated under 300 watt light illumination for photovoltaic applications. Additionally, interfacial properties of the MIS diode with GO interlayer were determined. It has been seen that the capacitance of the device changes as a function of gate voltage and signal frequency from the capacitance-frequency measurements. It has also been reported that the interfacial trap charges reduce the capacitance with increasing frequency values.Öğe Photoelectric and photocapacitance characteristics of Au/pyrene/N-Si MIS structures(Journal of Non-Oxide Glasses, 2017-04-01) Güllü, Ömer; Pakma, Osman; Özaydın, Cihat; Arsel, İsmail; Turmuş, MesutThis paper presents in-depth analysis of the current-voltage (I-V) and capacitance-voltage (C-V) characteristics of identically prepared Au/Pyrene(C16H10)/n-Si hybrid organic-oninorganic semiconductor photovoltaic cells (total 43 diodes). The barrier heights, ideality factors and reverse bias saturation currents of all devices were extracted from the electrical characteristics. The mean barrier height, mean ideality factor and mean saturation current from I-V measurements were calculated as 0.79 ± 0.01 eV, 1.40 ± 0.08 and (1.01 ± 0.46)x10-8 A, respectively. Also, the photoelectric (I-V) and photocapacitance (C-V and conductance (G)-voltage (V)) characteristics of the Au/Pyrene/n-Si device under 100 mW/cm2 light illumination were investigated. It has been seen that the light illumination increases strongly the current, capacitance and conductance values of the device due to electron-hole charge pair generation. The C-V and G-V characteristics under illumination have shown a non-monotonic dependence of capacitance on frequency giving rise to a peak. This is attributed to the existence of electrically active traps. The open circuit voltage and short circuit current of the Au/Pyrene/n-Si device were extracted as 80 mV and 30 µA, respectively.Öğe Electrical properties of organic–ınorganic semiconductor device based on rhodamine-101(SpringerLink, 2009-05) Güllü, Ömer; Turut, Abdulmecit; Yıldırım, Nezir; Çakar, MuzafferRhodamine-101 (Rh101) thin films on n-type Si substrates have been formed by means of evaporation, thus Sn/Rh101/n-Si heterojunctions have been fabricated. The Sn/Rh101/n-Si devices are rectifying. The optical energy gaps have been determined from the absorption spectra in the wavelength range of 400 nm to 700 nm. Rh101 has been characterized by direct optical absorption with an optical edge at 2.05 ± 0.05 eV and by indirect optical absorption with␣an optical edge at 1.80 ± 0.05 eV. It was demonstrated that trap-charge-limited current is the dominant transport mechanism at large forward bias. A␣mobility value of μ = 7.31 × 10−6 cm2 V−1 s−1 for Rh101 has been obtained from the forward-bias current–voltage characteristics.Öğe A study of the rectifying behaviour of aniline green-based Schottky diode(Elsevier, 2010-02) Güllü, Ömer; Aydoğan, ŞakirAn Al/aniline green (AG)/Ga2Te3 device was fabricated and the current–voltage (I–V), capacitance–voltage (C–V) and capacitance–frequency (C–f) characteristics of the device have been investigated at room temperature. The values of the ideality factor, series resistance and barrier height obtained from Cheung and Norde methods were compared, and it was seen that there was an agreement with each other. It was seen that the forward bias current–voltage characteristics at sufficiently large voltages has shown the effect of the series resistance. In addition, it was seen from the C–f characteristics that the values of capacitance have been decreased towards to the high frequencies. The higher values of capacitance at low frequencies were attributed to the excess capacitance resulting from the interface states in equilibrium with the Ga2Te3 that can follow the ac signal.Öğe Characterization of an Au/n-Si photovoltaic structure with an organic thin film(Elsevier, 2013-08) Özaydın, Cihat; Akkılıç, Kemal; İlhan, Salih; Rüzgar, Şerif; Güllü, Ömer; Temel, HamdiWe demonstrate that a copper(II) organic complex can control the electrical characteristics of conventional Au/n-Si metal-semiconductor (MS) contacts. We investigated the electronic and photovoltaic properties of a Cu(II) complex/n-Si heterojunction diode. The ideality factor n and barrier height Φb of the diode were 2.22 and 0.736 eV, respectively. An ideality factor greater than unity indicates that the diode exhibits non-ideal current-voltage behavior. This behavior results from the effect of series resistance and the presence of an interfacial layer. The series resistance and barrier height determined using Norde's method were 6.7 kΩ and 0.77 eV, respectively. The device showed photovoltaic behavior, with a maximum open-circuit voltage of 0.24 V and a short circuit current of 1.7 μA under light of 8 mW/cm2.Öğe Electrical characteristics of Co/n-Si schottky barrier diodes using I – V and C – V measurements electrical characteristics of Co/n-Si schottky barrier diodes using I – V and C – V measurements(Chinese Physics Letters, 2009-06) Güllü, Ömer; Güler, Gülşen; Karataş, Şükrü; Bakkaloğlu, Ömer FarukElectrical characteristics of Co/n-Si Schottky barrier diodes are analysed by current-voltage (I – V) and capacitance-voltage (C – V) techniques at room temperature. The electronic parameters such as ideality factor, barrier height and average series resistance are determined. The barrier height 0.76eV obtained from the C – V measurements is higher than that of the value 0.70eV obtained from the I – V measurements. The series resistance RS and the ideality factor n are determined from the d ln(I)/dV plot and are found to be 193.62Ω, and 1.34, respectively. The barrier height and the RS value are calculated from the H(I) – I plot and are found to be 0.71 eV and 205.95Ω. Furthermore, the energy distribution of the interface state density is determined from the forward bias I – V characteristics by taking into account the bias dependence of the effective barrier height. The interface state density Nss ranges from 6.484 × 1011 cm−2eV−1 in (EC – 0.446) eV to 2.801 × 1010 cm−2eV−1 in (EC – 0.631) eV, of the Co/n-Si Schottky barrier diode. The results show the presence of a thin interfacial layer between the metal and the semiconductor.Öğe Silicon MIS diodes with Cr2O3 nanofilm Optical morphological structural and electronic transport properties(Elsevier, 2010-04-15) Güllü, Ömer; Erdoğan, İbrahim YasinIn this work we report the optical, morphological and structural characterization and diode application of Cr2O3 nanofilms grown on p-Si substrates by spin coating and annealing process. X-ray diffraction (XRD), non-contact mode atomic force microscopy (NC-AFM), ultraviolet–visible (UV–vis) spectroscopy and photoluminescence (PL) spectroscopy were used for characterization of nanofilms. For Cr2O3 nanofilms, the average particle size determined from XRD and NC-AFM measurements was approximately 70 nm. Structure analyses of nanofilms demonstrate that the single phase Cr2O3 on silicon substrate is of high a crystalline structure with a dominant in hexagonal (1 1 0) orientation. The morphologic analysis of the films indicates that the films formed from hexagonal nanoparticles are with low roughness and uniform. UV–vis absorption measurements indicate that the band gap of the Cr2O3 film is 3.08 eV. The PL measurement shows that the Cr2O3 nanofilm has a strong and narrow ultraviolet emission, which facilitates potential applications in future photoelectric nanodevices. Au/Cr2O3/p-Si metal/interlayer/semiconductor (MIS) diodes were fabricated for investigation of the electronic properties such as current–voltage and capacitance–voltage. Ideality factor and barrier height for Au//Cr2O3/p-Si diode were calculated as 2.15 eV and 0.74 eV, respectively. Also, interfacial state properties of the MIS diode were determined. The interface-state density of the MIS diode was found to vary from 2.90 × 1013 eV−1 cm−2 to 8.45 × 1012 eV−1 cm−2.Öğe Ultrahigh (100%) barrier modification of n-InP Schottky diode by DNA biopolymer nanofilms(Elsevier, 2010-04) Güllü, ÖmerHere I demonstrate that DNA biopolymer molecules can control the electrical characteristics of conventional Al/n-InP metal–semiconductor contacts. Results show that DNA increases an effective barrier height as high as 0.87 eV by influencing the space charge region of n-InP device with a good rectifying behaviorÖğe Optical and structural properties of CuO nanofilm Its diode application(Elsevier, 2010-03-04) Güllü, Ömer; Erdoğan, İbrahim YasinThe high crystalline CuO nanofilms have been prepared by spin coating and annealing combined with a simple chemical method. The obtained films have been characterized by X-ray diffraction (XRD), Fourier transform infrared (FT-IR) spectroscopy, ultraviolet–vis (UV–vis) spectroscopy and photoluminescence (PL) spectroscopy. Structural analysis results demonstrate that the single phase CuO on Si (1 0 0) substrate is of high a crystalline structure with a dominant in monoclinic (1 1 1) orientation. FT-IR results confirm the formation of pure CuO phase. UV–vis absorption measurements indicate that the band gap of the CuO films is 2.64 eV. The PL spectrum of the CuO films shows a broad emission band centered at 467 nm, which is consistent with absorption measurement. Also, Au/CuO/p-Si metal/interlayer/semiconductor (MIS) diodes have been fabricated. Electronic properties (current–voltage) of these structures were investigated. In addition, the interfacial state properties of the MIS diode were obtained. The interface-state density of the MIS diode was found to vary from 6.21 × 1012 to 1.62 × 1012 eV−1 cm−2.
